- Chamberlain RSL12V garage door opener troubleshooting. The Chamberlain RSL12V model of garage door opener, like its RSL12VH version, was created for vehicular slide doors. It is accompanied by a solar panel kit (10 WATT) giving you a chance to replace or add a solar panel to the operator application.
- Sep 24, 2017 Programming/install your Chamberlain garage door opener Keychain Remote with Visor Clip (953EV/EVC) with this easy to follow video. LiftMaster remotes use the same programming steps.
Advertising
4
To exit programming mode, press
any remote control button except
the button that was just programmed.
any remote control button except
the button that was just programmed.
Repair Parts Home Appliance Parts Chamberlain Parts Chamberlain Garage Door Opener Parts Chamberlain Belt Drive Parts Chamberlain 349544 Whisper Drive. Continue Shopping Proceed to Checkout. We Sell Only Genuine Chamberlain Parts. Chamberlain 349544 Whisper Drive 3/4 HPS Garage Door Opener Parts. Find Part by Symptom. Model Number. Manual; Chamberlain 953EV Manual. 3-button remote controls. Chamberlain 953EV User Manual 2 pages. 953EVC, 956EV AND 956EVC For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after January 1, 1993. The garage door opener activates when the programmed button on the remote control is pressed.
The garage door opener
will activate.
will activate.
To test, press the programmed button on the remote control...
Using a safety pin or paper
clip, press the Program button
until the LED on the front of
the remote control turns on.
clip, press the Program button
until the LED on the front of
the remote control turns on.
1
2
Press and
release the
Learn button
on the garage
door opener.
release the
Learn button
on the garage
door opener.
Within 30 seconds...
The Learn LED will light.
3
Press and release the remote
control button you want to use...
control button you want to use...
Check to see if the garage door opener
light bulb blinks. If not, wait for the
remote control LED to light solid then
slowly press and release the remote
control button again. Repeat until the
light bulb blinks.
DO NOT press the button after the
light bulb blinks.
light bulb blinks. If not, wait for the
remote control LED to light solid then
slowly press and release the remote
control button again. Repeat until the
light bulb blinks.
DO NOT press the button after the
light bulb blinks.
5
![Chamberlain Model 956ev Evc User Manual Chamberlain Model 956ev Evc User Manual](/uploads/1/2/6/0/126009269/633413751.gif)
NOTICE: To comply with FCC and or Industry Canada rules (IC),
adjustment or modifications of this receiver and/or transmitter
are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Tested to Comply with FCC Standards for Home or office use.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
adjustment or modifications of this receiver and/or transmitter
are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Tested to Comply with FCC Standards for Home or office use.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
BATTERY
The LED on your remote will stop flashing when the battery is low and needs to be replaced.
To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery
with only 3V2032 coin cell batteries. Dispose of old battery properly.
To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery
with only 3V2032 coin cell batteries. Dispose of old battery properly.
To prevent possible SERIOUS INJURY or
DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
To reduce risk of fire, explosion or chemical
burn:
• Replace ONLY with 3V2032 coin batteries.
• DO NOT recharge, disassemble, heat
burn:
• Replace ONLY with 3V2032 coin batteries.
• DO NOT recharge, disassemble, heat
above 212° F (100° C) or incinerate.
1-800-528-9131
114A3924B
© 2012, The Chamberlain Group, Inc.
All Rights Reserved
REPLACEMENT PARTS
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20
Visor Clip
(Models 953EV & 953EVC ONLY) . . . . 29B137
(Models 953EV & 953EVC ONLY) . . . . 29B137
1
Chamberlain 953ev Evc Programming
2
3
WARRANTY
www.chamberlain-diy.com
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first retail purchaser of this product that is free from
defect in materials and/or workmanship for a period of 1 year from the date of purchase.
defect in materials and/or workmanship for a period of 1 year from the date of purchase.
Pry open the case with a screwdriver blade.
956EV & 956EVC
Pry open the case first in the middle (1), then
at each side (2 and 3) with the visor clip.
at each side (2 and 3) with the visor clip.
953EV & 953EVC
PROGRAM THE REMOTE CONTROL (956EV & 956EVC)
![Chamberlain Model 956ev Evc User Manual Chamberlain Model 956ev Evc User Manual](/uploads/1/2/6/0/126009269/858523489.png)
Advertising
This manual is related to the following products:
Popular Brands
Chamberlain 956ev Manual
Popular manuals